2200 Watt Weld-Less Heating Element 2200 Watt Weld-Less Heating Element 2 2200 Watt Weld-Less Heating Element 3 2200 Watt Stainless Steel Heating Element - great for hot liquor tank or boiler 2200 Watt Stainless Steel Heating Element - great for hot liquor tank or boiler 2200 Watt Stainless Steel Heating Element - with measurement
2200 Watt Weld-Less Heating Element

2200 Watt Weld-Less Heating Element

Product code : KL03506

Availability: In stock

These 304 Stainless 2200w Weld-Less Elements are designed to fit a 32mm Hole inside the wall of your brewing vessels or boilers. It does not come with the power cord (part code: KL03520).
Attachment guide: Element goes inside vessel with washer attached, then push through the electrical cord through the 32mm hole. Then pull over large hex nut over the electrical cord and tighten from the outside.

In Stock
$34.95
Description

2200 Watt Weld-Less Heating Element (304 Stainless Steel)
These weldless elements are designed to fit a 32mm hole in the wall of your brewing vessel or boiler.  It requires an IEC Power Cord to run (part code: KL03520).  Supplying power from an IEC cord allows the unit to be used in a smaller hole than if the cord was hard wired.
We do recommend using a MKII - Temperature Controller (Heat & Cool) to run this element with the appropriate thermowell or temperature probe attachment.

If you are going to be using these elements directly in your mash tun, and will try to maintain temperature using the element, we would also recommend getting a power control chip 3600w to modify the power output to the element. Too higher power directly in contact with your malted grain can cause scorching/off flavours as the temperature may not be evenly distributed and isolated purely around the element itself.

Highly recommended for your HLT, or even for a HERMS or RIMS setup.

Or for you distillers out there, it is possible to use a 50L Keg and drop some string onto the end of the power cord and pull through the keg without having to get your hand in there.
Powerful enough to use on 50-100L boilers and vessels. Multiple elements may be required for larger volumes and depending on what temperature you are trying to achieve.

When inserted into your vessel, this element will protrude 300mm. Please ensure you have enough room in your vessel to house this element prior to drilling.

Please note this does not come with an IEC Cord. Purchased separately.

BOIL TIME CALCULATORBoil Time Calculator

Volume:
Energy:
Start Temp:
End Temp: (Water boils at: 100°C/212°F)
Efficiency: %
Time to Temp: minutes
Delivery Information

Please ensure that your shipping information is 100% correct before submitting your order.
Once an order has been placed, KegLand cannot change/add to an order or change the shipping information.
Any such changes will fall onto the customer to contact the shipping provider and attempt redirection.
For larger items we do recommend that you use a business address as your primary shipping choice. This limits un-deliverable items as it will be delivered within business hours ensuring a recipient can sign for the package.

If you require extra items after you have placed your order, a secondary order will have to be placed with additional shipping costs.

Please note that some items are coming from multiple warehouse locations and may not be delivered at the same time.
Full Terms & Conditions.

Reviews
Write Your Own Review
You're reviewing: 2200 Watt Weld-Less Heating Element How do you rate this product? *
  1 star 2 stars 3 stars 4 stars 5 stars
Ratings
Instruction Manual
Video